Beach Tent set up instructions Lovin' Summer beach tents can be erected quickly and easily by one person by following 3 simple steps. STEP 1:Lay down centre cross bar pole on ground where you want to set up your tent. Place 2 yellow pole holders at each end of the cross bar and hammer in with mallet. Then insert 2 vertical poles into pole holders. Lift centre cross bar pole and attach on top of spikes of vertical poles. You now have a freestanding structure. STEP 2: Place tent over structure and insert spike of vertical poles through desired tent rings. STEP 3: Insert peg in sand at 45 degrees of tent corner with mallet then loop through corner tent rope through peg and attach clip back on rope. Repeat for all corners. Then revisit eachcorner and slide the clip further up the rope to fasten until taut. Voila ! Use the different rings on the tent to optimise shade angles from sun 99% UV protective Only beach tent that can be put up by one person 100 % cotton canvas material 260GSM Canvas Size 3.6 x 1.8 metres Folds out to give 3m of sun protection enough for your whole family 2 x upright poles and 1 top cross bar pole matt silver aluminium Poles are 23 mm diameter for extra strength and stability 2 x Pole stays - Lightweight polycarbonate cylindrical sand stay that holds the tent post in place on the sand whilst you set up your tent. Exclusive to Lovin' Summer 4 x Ropes - already connected to the canvas by swage and crimp for ease of erecting on first occasion. 4 x Guy rope clips that are quick and easy to use 4 x polycarbonate sand pegs 1 x Lightweight polycarbonate mallet 10 heavy duty double stitched eyelets for maximum strength Quality Reinforced edge webbing around the entire canvas Easy to carry with matching carry bag with hand or shoulder straps